H1 - Repair of decayed wood using paste repairs (< 300 ml)

  1. Remove all paint a couple of cm around the area to be repaired prior to cutting or sawing.
  2. Remove all decayed wood (including 5 mm of the surrounding sound wood ) with aid of a chisel, saw or cutter.
  3. If a chisel is used, remove broken or flattened wood fibres with a cutter.
  4. Sand bare wood.
  5. Check the wood mositure content level. If over 18%, let the wood dry.
  6. Apply a thin layer of Renofix primer on the surfaces to be repaired. Let it penetrate for at least 20 minutes and up to a maximum of 2 hours.
  7. Insert Renoflex repair paste into the opening. Make sure to bring the product in good contact with the wood. Avoid air pockets.
  8. After curing, sand. Preferably mechanically.
  9. Any irregularities can be treated with Renofast. Sand lightly after curing (1/2 hour).
  10. Finish with a paint system of your choice.
Close window

Disclaimer:
This website has been composed with the utmost care. No rights can be founded.
If in doubt, contact Renovaid by mail: info@renovaid.nl.