H4 - Repair of decayed wood using splicing (> 300 ml behind the glass line)

    A new sill or style is glued in with RENOFLEX.
  1. Remove all paint a couple of cm around the area to be repaired prior to cutting or sawing.
  2. Remove all decayed wood (including 5 mm of the surrounding sound wood) with aid of a chisel, saw or cutter.
  3. Sand bare wood.
  4. Prepare a new wooden part. Preferably of the same type of wood. In case of load bearing constructions, observe an angel of 90ยบ.
  5. Observe a seam of 1/2 to 1 cm for gluing.
  6. Apply a thin layer of Renofix primer on the contact area's. Including the new wooden part. Let it penetrate for at least 20 minutes and up to a maximum of 2 hours.
  7. Apply a thin layer of Renoflex repair paste onto the contact area's. Make sure to bring the product in good contact with the wood. Avoid air pockets.
  8. Apply a thick layer of Renoflex in such a way that the seam will be fully filled when the new sill of style is placed.
  9. Remove excess material with a spatula.
  10. After curing, sand. Preferably mechanically.
  11. Any irregularities can be treated with Renofast.
  12. Sand lightly after curing (1/2 hour).
  13. Finish with a paint system of your choice.
Close window

Disclaimer:
This website has been composed with the utmost care. No rights can be founded.
If in doubt, contact Renovaid by mail: info@renovaid.nl.