H3 - Repair of decayed wood using a laminating system (> 300 ml in front of the glass line)

    A new wooden part is glued in with RENOFAST. Use this method when great speed is required.
  1. Remove all paint a couple of cm around the area to be repaired prior to cutting or sawing.
  2. Remove all decayed wood (including 5 mm of the surrounding sound wood) with aid of a chisel, saw or cutter.
  3. If a chisel is used, remove broken or flattened wood fibres with a cutter.
  4. Sand bare wood.
  5. Prepare a new wooden part. Preferably of the same type of wood. Observe a seam of 5 mm to max 7 mm for gluing.
  6. Apply a thin layer of Renofast fast curing repair paste onto the contact area's. Make sure to bring the product in good contact with the wood. Avoid air pockets.
  7. Apply a thick layer of Renofast (max 7 mm) and press the new wooden part into the layer.
  8. Make sure the seam is fully filled.
  9. Remove excess material with a spatula.
  10. After curing, sand. Preferably mechanically.
  11. Any irregularities can be treated with Renofast. Sand lightly after curing (1/2 hour).
  12. Finish with a paint system of your choice.
Remark: In view of the fast curing of the Renofast, it is imperative to prepare the repair well and work fast and accurately.
Close window

Disclaimer:
This website has been composed with the utmost care. No rights can be founded.
If in doubt, contact Renovaid by mail: info@renovaid.nl.