H2 - Repair of decayed wood using a laminating system (> 300 ml in front of the glass line)

    A new wooden part is glued in with RENOFLEX.
  1. Remove all paint a couple of cm around the area to be repaired prior to cutting or sawing.
  2. Remove all decayed wood (including 5 mm of the surrounding sound wood) with aid of a chisel, saw or cutter.
  3. If a chisel is used, remove broken or flattened wood fibres with a cutter.
  4. Sand bare wood.
  5. Prepare a new wooden part. Preferably of the same type of wood. Observe a seam of 1/2 to 1 cm for gluing.
  6. Apply a thin layer of Renofix primer on the contact area's. Including the new wooden part. Let it penetrate for at least 20 minutes and up to a maximum of 2 hours.
  7. Apply a thin layer of Renoflex repair paste onto the contact area's. Make sure to bring the product in good contact with the wood. Avoid air pockets.
  8. Apply a thick layer of Renoflex and press the new wooden part into the layer.
  9. Make sure the seam is fully filled.
  10. Remove excess material with a spatula.
  11. After curing, sand. Preferably mechanically.
  12. Any irregularities can be treated with Renofast. Sand lightly after curing (1/2 hour).
  13. Finish with a paint system of your choice.
Close window

Disclaimer:
This website has been composed with the utmost care. No rights can be founded.
If in doubt, contact Renovaid by mail: info@renovaid.nl.