V13 - Opening of sealed frame-masonry joints

  1. Remove all putty between frame and masonry. E.g. with the use of a Renovaid dilitation saw.
  2. Sand the resulting seams and thoroughly remove loose wood fibres, paint, wood rests and dirt.
  3. Apply Renobond glue and end grain sealer into the seams to prevent moisture ingress.
  4. After curing of the Renobond (depending on temperature 16 to 24 hours), sand.
  5. Finish with a paint system of your choice.
Raamdorpelsteen
    Joint window sill - brick work
  1. Use a Renovaid dilitation saw to remove the bottom part of the wooden sill to ensure sufficient ventilation.
  2. Remove thoroughly all fibres, wood rests and dirt. Use tape to protect the bricks against contamination with Renobond.
  3. Apply Renobond glue and end grain sealer into the seam to prevent moisture ingress.
  4. After curing of the Renobond (depending on temperature 16 to 24 hours), sand.
  5. Finish with a paint system of your choice.


Risk: Lack of ventilation prevents the evaporation of ingressed moisture (e.g. via leaking glazing systems indoors or the elevation construction). This will lead to wood decay.

Close window

Disclaimer:
This website has been composed with the utmost care. No rights can be founded.
If in doubt, contact Renovaid by mail: info@renovaid.nl.