V6 - Sealing of porous substrates (End grain wood, etc.)

  1. Remove the paint system around the affected area.
  2. Remove weathered wood.
  3. Check the wood moisture content level. If over 18%, let the wood dry.
  4. Apply a thin layer of Renofix primer on the end grain wood and let it penetrate for at least 20 minutes and up to a maximum of 2 hours.
  5. Apply a thin layer of Renobond glue and end grain sealer with a brush or spatula on the end grain wood.
  6. After curing, sand. Preferably mechanically.
  7. Finish with a paint system of your choice.
Close window

Disclaimer:
This website has been composed with the utmost care. No rights can be founded.
If in doubt, contact Renovaid by mail: info@renovaid.nl.